home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Cream of the Crop 1
/
Cream of the Crop 1.iso
/
EDUCATE
/
QMTEK601.ARJ
/
DESQMEM.TEC
< prev
next >
Wrap
Text File
|
1991-03-11
|
2KB
|
41 lines
ID:DM Memory usage by DESQview
Quarterdeck Technical Note #111
by Dan Sallitt
Q: How much memory does DESQview use?
In its unmodified state, DESQview 2.2 takes up, somewhere in
memory, between 145K and 180K. The differences are due to
various drivers that DESQview may or may not load depending on
its setup configuration and the hardware on which it is running.
The low-end figure of 145K can be reduced a bit by throwing away
features in DESQview's Setup. On a machine with only 640K of
memory, all of DESQview's code resides in conventional memory.
If your machine has extended memory, DESQview can place 63K of
its code at the beginning of extended memory with our QEXT.SYS
driver and our XDV.COM loader.
If your machine has any kind of expanded memory, DESQview can
place 32K of its code (slightly more on a VGA system) in the EMS
page frame with XDV.COM, switching this code out of harm's way
when the page frame is in use. When both extended and expanded
memory are present, DESQview can therefore remove about 95K of
itself from conventional memory.
If your machine's expanded memory permits the mapping of
additional pages of expanded memory between 640K and 1024K,
DESQview can place even more of its code in high RAM with
XDV.COM. On a machine that provides enough free mappable pages
between 640K and 1024K, it is common to observe that DESQview
leaves little more than 1K of its code in conventional memory.
(When computing DESQview's overhead in running a program, you
should remember that a certain amount of memory - 9K, on the
average - is taken as overhead when a window is opened. This
figure can be decreased a small amount by manipulating the Change
a Program menus for the program in question.)
Copyright (C) 1991 by Quarterdeck Office Systems
* * * E N D O F F I L E * * *